P     a     r     a     c     h     u     t     e     H     i     s     t     o     r     y     .     c     o     m

 

Featured Exhibits

Products

Services
 
Site Map
 
SkyPeople


Sign up for the Newsletter

Advertise on ParachuteHistory.com



Disclaimer
Privacy Policy
About

 



You are Here: Parachute History.com >> Malfunctions >> Manufacturing or Assembly Flaw

Manufacturing or Assembly Flaw

Jumpers may be considered as consumers of parachute equipment. As such, they expect that equipment is manufactured and assembled properly.

On rare occasions the manufacturer or rigger assembling the equipment fails to ensure safe equipment.

1982
Craig Fenstermaker, B-11652, reported that the left rear riser was not sewn together. It was only glued. Upon jumping, he had a spinning malfunction, cutaway and successfully deployed his reserve. The gear was new as he was making a gear transition from a ripcord with Capewells to a hand deploy and 3-rings. Adequate training and practice of emergency procedures allowed Craig to tell us about his experience.

Not only did the riser manufacturer miss the unsewn riser, so did Craig when he assembled the main.

You are Here: Parachute History.com >> Malfunctions >> Manufacturing or Assembly Flaw

Top   |  [Featured Exhibits]   |  [Site Map]
[Products]   |  [Services]
[Join Our Mailing List]   |  [Advertise on ParachuteHistory.com]
[ ]
[Disclaimer]   |  [Privacy Policy]   |  [About]

 

 
P     a     r     a     c     h     u     t     e     H     i     s     t     o     r     y     .     c     o     m

© Copyright 2001-2003 by ParachuteHistory.com
All Rights Reserved.
This site has been rated and approved for General Audiences by : ICRA and Safe Surf

Web Design: